The Effect of Surface Roughness Profile on Micropitting

The Effect of the Surface Roughness Profile on Micropitting

By : Gary Sroka , Matt Bell ,

Abstract

By: Matt Bell, Dr. Gary Sroka and Dr. Ron Benson, REM Surface Engineering

A wide choice of surface roughness parameters is available to characterize components, such as gears or bearings, with the goal of predicting the performance of such metal–to–metal contacting parts. Commonly in industry the Roughness Average (Ra) or the Mean Peak–to–Valley Height (Rz (DIN)) is chosen to calculate the Specific Film Thickness Ratio for both superfinished and honed surfaces. However, these two surface roughness parameters fail to adequately predict the performance properties of surfaces that are superfinished or surfaces that are honed. In this paper, a superfinished surface is defined as a planarized surface having a ≤0.25 mm Ra. A honed surface is not considered to be planarized, even with a finish of ≤0.25 mm Ra. Thus, one is falsely led to predict that a planarized surface or a honed surface, having an equivalent Ra or Rz, will perform similarly. Experimentally, an isotropic planarized surface delivers superior performance. The following discussion utilizes another roughness parameter, 3σ50, to further explain this phenomenon.

 

Copyright  2012

American Gear Manufacturers Association

October 2012

ISBN: 978–1–61481–051–3

Download Resource

Please fill out the information below to receive the selected resource.

Download Resource New Form

Please fill out the information below to receive the selected resource.

Have Questions?

Talk to an expert