mass finishing equipment Archives - REM Surface Engineering

Roughness Measurement Tips: The Scratch Pad

Posted by Mark Michaud on Thursday, January 16th, 2020 in

You can check a profilometer’s overall performance following a quality-control-defined procedure and frequency using this traceable calibration specimen. By Mark Michaud […]...

A Comparison of Surface Roughness Measurement Methods for Gear Tooth Working Surfaces

Posted by Mark Michaud on Friday, October 25th, 2019 in

A Comparison of Surface Roughness Measurement Methods for Gear Tooth Working Surfaces Matthew Wagner, Aaron Isaacson, Mark Michaud, and Matt […]...

Vibratory Media Compositions vs. Attrition and Density

Posted by Bill Nebiolo on Tuesday, October 1st, 2019 in

Vibratory media composition vs. attrition and density WILLIAM P. NEBIOLO PRODUCT MANAGER REM SURFACE ENGINEERING Media content is based […]...

AN ANALYSIS OF A LOSS OF LUBRICATION TEST OF ISOTROPIC SUPERFINISHED GEARS WITHOUT BLACK OXIDE COATING

Materials Matter : Surface Finishing Rotorcraft Gearing

Posted by Danny Estrada on Wednesday, October 3rd, 2018 in

An analysis of a loss of lubrication test of Isotropic Superfinished gears without black oxide coating. By Lane Winkelmann Rotorcraft gearboxes are […]...

Comparative Corrosion Characteristics of Gear Steels 1

Comparative Corrosion Characteristics of Ground and Superfinished Gear Steels

Posted by David Smith on Friday, November 15th, 2013 in

Comparative Corrosion Characteristics of Ground and Superfinished Gear Steels By Suren Rao, Doug McPherson Gear Research Institute The Pennsylvania State University […]...